How to clean the filters of the Jet Bot AI+ and Clean Station

Let’s start to detach the filters in the Jet Bot AI+.

Detach filters

• First, press the power switch to turn the Jet Bot AI+ device off.
• Slide up and detach the Upper cover.
• Take hold of the Dustbin handle and lift it out of the machine.
• Unlock the transparent clip at the side to open the upper cover of the Dustbin.
• Remove the Pre-motor filter from the Dustbin.
• Unlock the transparent clip at the bottom to open the lower cover of the Dustbin.
• Next, detach the Fine dust filter.
• Slightly press the grooves on both sides of the Fine dust filter and lift it out.
• Now, all of the filters are detached.

Remove dust from the filters

• Remove dust from the Dustbin filters. If needed, use a soft brush to remove debris from the filters.
• Rinse the filters under running water. All parts and filters of the Jet Bot AI+ are washable.
• Place the filters in a well-ventilated shaded area until completely dry. Keep the filters away from direct sunlight.

Let’s start to detach the filters on the Clean Station.

• Dust bag
• Fine dust filter

Filter replacement

• Press the button on top to open the upper lid. 
• Gently pull the blue latch inside and slowly pull the Dust bag up. Throw the used Dust bag into the trash can. 
• Unfold a new Dust bag. Gently place the new Dust bag inside.
• Push the blue latch back to secure the new bag. Now, Dust bag replacement is complete. 

Clean the filters

Next, pull the sides to remove the back cover.

• Gently pull out the Fine dust filter. Remove any dust on the Fine dust filter. The Fine dust filter is not washable. Do not use water to clean the Fine dust filter.
• To maintain the best performance of the Fine dust filter, replace the filter at least once a year. Reinstall the Fine dust filter.
• Insert the back cover in place once again.