What should I do if water drips from the dispenser?

Inspect the water lines and couplers

If the water line under the hinge cover is not connected properly when the doors are put back on, air can get into the water coupler. Make sure it is not bent at the coupler because this will allow air in and cause a drip.

To reach the water coupler, review the steps for removing and reinstalling the doors in your user manual.

Purge the air from the water line

If the water filter was recently replaced or your refrigerator was recently installed, dispensing water will help remove any trapped air and stop the water dispenser from leaking. Dispense water into a large pitcher until it automatically stops.

• If the water stream sputters while dispensing, empty the container when it stops and dispense again three more times if it sputters each time.
• If the stream is steady and the dripping stops, it is safe to assume that there is no more air in the water line.
• If the dripping continues, you need to check the water line and couplers.

• If you use the water dispenser (water line) without the installation of the water filter, foreign substances from your tap water may flow into the water pipe and cause defects.
• Please install the filter properly by referring to the user manual because it can be prevent leaking.