How to clean the Inlet Filters In my Washing Machines

Last Update date : Jul 21. 2022

Please Note: The information on this page is for New Zealand products only. Sequences or settings will vary depending on location and/or where the product had been purchased. To be redirected to your local support page please click here.

To clean the inlet water supply filters follow the steps below:

1 Remove the hot and cold water inlet supply hoses from the back of the washing machine.
2 Locate the inlet hose filter inside of the hot and cold water inlets on the back of the washing machine.
back of unit
3 Remove the filters by pulling them straight out by the tab in the center of the filters.
filters

Tip: You may need to use needle nosed pliers to remove the filters as they are very small.

4 Run the filters under warm water and gently scrub until any visible debris is removed. Be careful not to damage the filter screens. If damaged they will need to be replaced before using the machine again.
5 Place the filters back into the inlets on the back of the washing machine.

Important: When re-installing the inlet hose filters make sure the tabs on the filters are facing outward.

For all other queries or further technical assistance, please call Samsung Customer Care on 0800 726 786 or Live Chat with our Technical Team online, services are open 24 hours, 7 days.

Thank you for your feedback!

RC01_Static Content : This text is only displayed on the editor page