Clean with your Jetbot Mop

Ensure your Jetbot Mop is fully charged before beginning a cleaning cycle. Plug in and charge the Jetbot Mop until the LED indicator light turns off.

Next, you’ll need to attach the mop pads to the water supply kits. Make sure the mop pads are clean before using them. Two types of mop pads are included:

Attach the mop pads to the water supply kits using the Velcro sides.

Next, fill the water supply kits with clean water. Open the rubber cap on the water supply kit, pour in the water, and then close the cap. 

Note: Do not use any other liquids when filling the water supply kits.

Attach the water supply kits to the bottom of the Jetbot Mop by carefully pressing down and turning them to the side. You’ll hear a click when the water supply kits are attached.

Press and hold the Operation button on the Jetbot Mop for two seconds until you hear a beep and the light stays on.

If there is any remaining water in the water supply kits after cleaning, remove the kits and drain them.

Before using Handy Cleaning mode, make sure the Jetbot Mop is fully charged, the mop pads are attached, and the water supply kits are attached.

Pick up your Jetbot Mop by its handle, and press and hold the Operation button to turn it on.

Press the Operation button twice to enable Handy Cleaning mode. The mop pads will begin rotating. Use the mop to clean up any messes.

Turn off Handy Cleaning mode by pressing the Operation button twice. You can also press the Start/Stop button on the remote control.