How to unbox and set up your Samsung Jetbot Mop

Remove all of the protective film and packaging material from the JetBot Mop. In particular, make sure to remove the clear film that covers the sensors so they can work correctly.

Start by charging the main unit of your Jetbot Mop with the power adapter. Leave it plugged in until the LED notification light turns off.

Next, select your mop pads. Wash them using clean water and a natural detergent, and scrub them gently with the silicone brush. Allow them to dry thoroughly before proceeding to the next step.

Then, attach the mop pads to the water supply kits using the Velcro sides.

The water supply kits will need to be filled with clean water and attached to the main unit. Open the small rubber caps on the water supply kits to fill them. Make sure the rubber caps are closed tightly before attaching them to the bottom of the main unit. Press down gently while turning them from side to side to secure them to the main unit; they will click when they are attached.

Press and hold the Operation button on your Jetbot Mop for two seconds. You’ll hear a beep, and the light will stay on.

Now you can begin cleaning! When you’re finished, make sure to disassemble the water supply kits and mop pads. The water supply kits should be drained of any remaining water and the mop pads should be cleaned with natural detergent and left to dry.

Store the main unit on the floor plate in a cool, dry place.

Separate the water supply mop kit from the main unit after you're done using the mopping robot. Pull out the water supply mop kit by hand. If it is hard to pull out, twist it a little bit.

Open the rubber cap and pour out any remaining water from the water supply mop kit.