How to adjust the Bespoke fridge's door height

Four-door models

1. Open the right-side door of the freezer. Keep the other freezer door and both fridge doors closed. Locate the height lever on the bottom of the right-side door.
   Note: We recommend keeping items in the door bins during the alignment process. Leaving the bins empty could affect the doors' alignment later on.
2. Turn the height lever toward UP to raise the right-side door, or turn it toward DOWN to lower the door. To make alignment easier, you can lift the fridge door slightly while adjusting.
   
3. If the doors are still not aligned but you cannot adjust the height lever any further, try using the snap rings.
   Note: You should only use the snap rings if you cannot align the doors with the height lever.
4. The snap rings come in 4 different sizes: 1 mm, 1.5 mm, 2 mm, and 2.5 mm. Check the height difference between the doors, and then choose the snap ring that you think will correct the height difference.
   Note: Insert only one snap ring per door. If you insert two or more snap rings, the rings may slip out or make a rubbing noise.
5. Once you've chosen your desired snap ring, lift up and hold the door with the lower height.
6. Insert a suitably sized snap ring between the door grommet.
   
7. If needed, repeat these steps to adjust the height of the other top-side door.

Three-door models

1. Check the height difference between the doors, and then lift up and hold the door with the lower height. 
2. Insert a suitable-sized snap ring between the door grommet and the hinge.

You can adjust the height of the bottom freezer doors if they appear uneven. Before adjusting the doors, make sure the refrigerator is level. Check out the video in the first section for additional information.

1. Open the door you’d like to adjust, and then lift it slightly.
2. Next, locate the height lever at the bottom of the door.
3. The height lever includes a grommet that can be moved inward or outward to adjust the door height by 1 mm.
4. Turn the grommet in your desired direction to raise or lower the door. If you need to increase the door’s height, turn the grommet outward. To decrease the door’s height, turn the grommet inward.
5. If needed, repeat these steps to adjust the other bottom door.

The height of your side-by-side Bespoke refrigerator doors can be adjusted via the clamp and height nuts on the front bottom of the door. Follow these steps.

1. Open the door you want to adjust.
2. Locate the two nuts on the front bottom of the door.
3. Using a 19mm spanner, turn the clamp nut clockwise to loosen, and then open the door.
4. Inside the door, turn the height nut counter clockwise to raise it or clockwise to lower it.
5. When finished, tighten the clamp nut by turning counter clockwise.