Blank or black display on a Samsung phone or tablet

Verify the phone, tablet, charger, and USB cable have no physical or liquid damage.

• Remove any cases or other accessories that may cover the charging port or buttons.
• Check the USB connections for corrosion and bent pins. The USB connection should be firm with very little mobility.
• Inspect the Liquid Damage Indicator (LDI). The LDI should be solid white, or white with pink or purple X's.

1. Power off your phone or tablet, and insert the ejector tool into the small hole next to the SIM/MicroSD tray. This will eject the tray.
2. Shine a flashlight into the SIM/MicroSD slot.
   • If the device has been exposed to moisture, the LDI will be solid pink, purple, or red. Service is required.
   • If the device has not been exposed to moisture, the LDI will be solid white or solid white with pink or purple Xs.

Normal LDIs

An LDI exposed to liquid

There are two ways you can force a restart on your device:

• Press and hold the Power button (or Side button) and Volume down button for 20 seconds.
  
  
  
• On devices with removable batteries, remove the battery for 60 seconds, and then reinsert it.

Connect and charge the phone or tablet using the appropriate charger for at least 1 hour. The battery charging indicator may take up to 10 minutes to appear on the display.

Disconnect the phone or tablet and then attempt to turn it on by pressing and holding the Power button (or Side button) for 15 to 20 seconds. The Samsung Galaxy logo will appear.

• If the screen turns on, your device requires a charge. Turn off your device and reconnect it to the appropriate charger until it's fully charged.
• If the screen fails to turn on after performing the previous steps, your device needs service. Contact the Samsung Support Center for further assistance.